How To Reset Printer Canon IP 1980

 Printer Canon iP1980 need to reset in the event:

1. Blink 4x 1x orange green. (specifically how to solve this blink click HERE)
2. Green orange flashing alternately during 7x (Ink Absorber Full),
3. Orange 8x ink tank full

The following steps IP1980 Reset:

1. Driver must already be installed. If you do not have a driver click here.
2. The printer must be in a state of service mode (temporary reset).

To activate the service mode:
           * Unplug the electrical power
           * Press the power (on the printer)
           * Plug the electrical power (light turns green)
           * While holding the power press the resume button (light turns orange)
           * Remove the two (the printer will die)
           * Press the power button again and immediately release. (light turns green) (do not disconnect power  electric)
3. Start the General Service Tool. If you do not have, download here.
4. Unplug the electric power, plug back in and turn (initial printer / wait until the non-blinking lights. Done
How to run the General Service Tool

 

   1. Exctrak files that you download

    2. Windows should be 1024x768 resolution
    3. Run the file "GeneralTool.exe"
    4. Select the USB Port
    5. Check Cleaning and EEPROM Clear
    6. Click Play
    7. Click Platen
    8. Done Quit
    9. Turn the printer off by pressing power.
Done, and then you just try to unplug the power cable printer and put it back, then turn your printer on.
Good luck.